 FE
Cylinder Head Rebuild -
Continued
Ford FE Engines
<BACK
TO PAGE THREE
Painted with a few coats of Ford
Blue engine paint, the new gaskets are set and the heads bolted into
place.
 Prior
to installation, all the head bolts were chased clean and
checked. All cylinder block holes were also chased
cleaned with a bottom tap.
Less than .005 of an inch was
removed from the intake side of the head, if more than .020 is
taken off, machining of the intake manifold is required to
assure a tight seal.
 We
would like to thank Randy Stevens, Jeff Manges, Mike
Kollross and the whole gang at Sacramento
Cylinder Head for tanking part in Project F-100 and
providing us with quality rebuilt heads.
You don't have
to live in Sacramento to get this type of service, Sacramento
Cylinder Head provides world wide service on both cast
iron and aluminum cylinder heads for just about any
application. See their website
for more details.
<BACK
TO PAGE THREE
- PROJECT
SECTION HOME>
|
